Last Modified: 11-29-2007 1.6 A
Service Category: Engine/Hybrid System Section: Fuel System
Model Year: 2008 Model: Sequoia Doc ID: RM000000YLI010X
Title: 3UR-FE FUEL: FUEL PUMP: INSTALLATION (2008 Sequoia)

INSTALLATION

1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

(a) Apply a light coat of gasoline or grease to a new gasket, and install it to the fuel tank.

(b) Install the fuel suction with pump and gauge tube assembly into the fuel tank.

NOTICE:

  • Be careful not to bend the arm of the fuel suction with pump and gauge tube assembly.
  • Align the protrusion of the fuel suction with pump and gauge tube assembly with the groove of the fuel tank.

(c) Put the retainer on the fuel tank. While holding the fuel suction with pump and gauge tube assembly, tighten the retainer one complete turn by hand.

(d) Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank, as shown in the illustration.

SST: 09808-14020

HINT:

Fit the tips of SST onto the ribs of the retainer.

(e) Install the 2 fuel tank tubes with the 2 tube joint clips.





NOTICE:

  • Check that there are no scratches or foreign objects on the connecting parts.
  • Check that the fuel tube joints are inserted securely.
  • Check that the tube joint clips are on the collars of the fuel tube joints.
  • After installing the tube joint clips, check that the fuel tube joints have not been pulled off.

2. INSTALL FUEL TANK ASSEMBLY

(a) Install the fuel tank assembly 3UR-FE FUEL: FUEL TANK: INSTALLATION (2008 Sequoia) .